Current control with only one phase and not motor

To get my current control working, I will initially only use the resistor bank and one phase (C as it has a current sensor in it)

I will have to do several things to set this up.

Alter the labview program so that it logs with time rather than with encoder position

DONE

Alter the simulink program to only put out on phase

DONE

Try open loop block wave output from simulink and log in labview

REALLY NEEDED TO HAVE SOME INDUCTANCE - REMOVED ROTOR AND CONNECTED ONE MOTOR PHASE

try open loop sine wave output from simulink and log in labview

DONE - TIME TO START ANOTHER BLOG JUST ON CURRENT CONTROL

attempt closed loop control using block wave (may need to use a motor phase instead of the resistor bank as there may not be enough inductance to allow proper current control)