i had an idea in the shower

maybe now that I am not using any of the "to memory" or "from memory" blocks other than those that reference the registers, I can use the standard memory map. Then i can use a .cdb file and have a look at the cpu loading and stuff.


pid_current_control_rtdx_3.mdl

check that it works without rtdx

works

remove the config block and replace with default

needed to change the name to: F2812 eZdsp

got the following error message when ccs tried to load the .out file

Data verification failed at address 0x100000
Please verify target memory and memory map



then

Data verification failed at address 0x1081C0
Please verify target memory and memory map



then

1081c2

1080e2

than three others

try to set up using internal memory map

SEEMS TO WORK - NOW I CAN TRY TO USE A CDB FILE

adding a .cdb file gives me 1 error

I tried to run with an rtdx block but no reference to rtdx in the cmd file.

motor squeeled and drew heaps of current then stopped working. Thankfully it still works when I remove the rtdx block and rebuild